Horizon Fitness TREADMILL WT751 User Manual page 8

PR E - ASS E M BLY
WARNING
NOTE:
During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before
completely tightening any ONE bolt. NOTE: A light application of grease may aid in the installation of hardware.
Any grease, such as lithium bike grease is recommended.
AS SE MB LY S T EP 1
HARDWARE BAG 1 CONTENTS :
* NOTE: If the straps have been removed before completing step 1-D and the linkage arms can not be
aligned, refer to the TROUBLESHOOTING section in order to restore the treadmill to its proper position.
7
DO NOT CUT STRAPS UNTIL STEP 1-E!*
cardboard packaging that is not beneath the treadmill. Do not attempt to lift the
treadmill at this time. Remove plastic wrap from console masts.
Disassemble box and remove the
A
Open HARDWARE BAG 1.
B
Lift LEFT CONSOLE MAST into
upright position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it's own.
C Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A)
and tighten.
D
Repeat on the right side.
E
Now cut the banding straps and
remove remaining packaging
material.*
F Lift the RUNNING DECK until
lock latch on side of treadmill
is fully engaged.
G
Remove CONSOLE from box
and place out of the way.
H
Lower the treadmill RUNNING
DECK from the folded position
by stepping on LOCK LATCH on
lower right side.