3: Activating your Raven XE on your
cellular provider
•
OMA-DM
•
Hands Free
Activation (HFA)
•
Activating Raven
XE
•
Verifying USB
connection
•
Configuring through
ACEmanager
•
Activating Using AT
Commands
Rev 2.0 Mar.10
This chapter provides step-by-step directions for activating your
Raven XE on your cellular provider's network.
OMA-DM
Raven XE is an embedded router solution that supports Network
Initiated (NI) OMA-DM Device Configuration (DC) and PRL Updates
(PRL) on the Sprint network. The Raven XE firmware registers
notifications with the MC5727 radio module for OMA-DM NI alerts
and session state and processes them appropriately. The alert
response instructs the radio module to immediately process the NI
OMA-DM command. When the OMA-DM session state is IDLE,
Raven XE records the session type and session result code and then
re-establishes the data connection.
Hands Free Activation (HFA)
Raven XE automatically detects the radio module installed during
system startup. If the radio module is CDMA technology, Raven XE
will check the current provisioning state and if necessary execute
HFA. For devices that have previously been provisioned the HFA
routine is bypassed.
Activating Raven XE
To activate your Raven XE, follow the instructions below:
1. Connect the Raven XE with antennas.
2. Plug the power cable to the power connector on the back panel of
the Raven XE.
3. Connect your computer to the Raven XE with an ethernet cable.
3
15