Completing The Parts Replacement - Lenovo ThinkCentre Hardware Maintenance Manual

Figure 32. Replacing the rear fan assembly
9. Connect the rear fan assembly cable to the system fan connector on the system board.
10. To complete the replacement, go to "Completing the parts replacement" on page 98.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover
and reconnect cables.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws are
left inside your computer. See "Locating components" on page 72 for the locations of the various
components in your computer.
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 77.
3. Properly route the cables and keep them clear of the hinges and sides of the computer chassis to
avoid interference with closing the computer cover.
4. Position the computer cover on the chassis so that the rail guides on the bottom of the computer cover
engage the rails. Then, slide the computer cover to the front of the computer until it snaps into position
and is closed. Then, install the two screws to secure the computer cover.
98
ThinkCentre Hardware Maintenance Manual