Assembly - Horizon Fitness FITNESS T701 Owner's Manual

asse mB lY
imPOrTanT: read THese saFeTY insTruCTiOns BeFOre use!
WARNING
During the assembly process of the treadmill there are several areas that special attention must be
paid. It is very important to follow the assembly instructions correctly and to make sure all parts are
firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have
frame parts that are not tightened and will seem loose and may cause irritating noises. There should
be no side-to-side play in the console masts or any forward and back play in the console assembly
or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To
prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions
should be taken.
unPaCKinG
Place the treadmill carton on a level flat surface. It is recommended that you place a protective
covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when
it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless
it is fully assembled and in the upright folded position or until specified in the assembly instructions.
Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks
and may spring open if mishandled. Never grab hold of any portion of the incline frame and attempt to
lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
Before proceeding, find your treadmill's serial number
and model name located below the on/off power switch
and power cord and enter it in the space provided
below.
enTer YOur serial numBer and
mOdel name in THe BOxes BelOw:
SERIAL NUMBER:
MODEL NAME:
* Refer to the SERIAL NUMBER and MODEL NAME when calling for service.
* Also enter this serial number on your Warranty Card.

T701_Rev.1.2.indd 6-7
READING RACK
WATER BOTTLE HOLDER
GRIP PULSE HANDRAILS
ON/OFF SWITCH
CIRCUIT BREAKER
POWER CORD
RUNNING BELT / RUNNING DECK
TRANSPORT WHEEL
TOOLS INCLUDED
Screwdriver
6 mm T-Wrench
5 mm L-Wrench
PARTS INCLUDED
1 Console Assembly 1 Audio Adaptor Cable
2 Console Masts 1 Bottle of Silicone Lubricant
2 Bottom Console Covers 3 Hardware Bags
1 Safety Key
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
For a complete exploded diagram, visit us at www.horizonfitness.com
TOUCH PAD PANEL AND DISPLAY WINDOWS
SAFETY KEY PLACEMENT
CONSOLE MAST
FOOT LOCK LATCH (UNDERNEATH DECK)
MOTOR COVER
SIDE RAIL
ROLLER END CAP
REAR ROLLER ADJUSTMENT BOLTS
7
9/17/08 4:55:43 PM