Speaker Assembly - HP EliteBook 8730w Maintenance And Service Manual

Reverse this procedure to install the USB/eSATA board.

Speaker assembly

Description
Speaker assembly
Before removing the speaker assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Battery (see
b. Keyboard (see
c. Switch cover (see
d. Display assembly (see
e. Top cover (see
Remove the speaker assembly:
1. Remove the two PM2.5×4.0 screws (1) that secure the speaker to the base enclosure.
2. Disconnect the speaker cable (2) from the system board.
3. Remove the speaker assembly (3) from the base enclosure.
Battery on page 41)
Keyboard on page 55)
Switch cover on page
Display assembly on page
Top cover on page 78)
59)
70)
Component replacement procedures
Spare part number
494029-001
83