Lexmark MX810 Series User Manual page 175

Understanding the printer menus
Use
NPA Mode
Off
Auto
Network Buffer
Auto
3KB to [maximum size allowed]
Job Buffering
Off
On
Auto
Mac Binary PS
On
Off
Auto
Standard Network Setup OR
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
To
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
•
Auto is the factory default setting.
• Changing this setting from the printer control panel, and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
•
The value can be changed in 1KB increments.
•
The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Temporarily store print jobs in the printer hard disk before printing. This menu only
appears when a formatted disk is installed.
Notes:
• Off is the factory default setting.
•
On buffers print jobs on the printer hard disk.
•
Auto buffers print jobs only when the printer is busy processing data from
another input port.
•
Changing this setting from the printer control panel, and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
•
Auto is the factory default setting.
• Off filters print jobs using the standard protocol.
•
On processes raw binary PostScript print jobs.
Show and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a wireless
network.
175