Horizon Fitness LS 645E User Manual page 5

CONSOLE MAST BOOT
AS SE MB LY ST EP 2
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
TOP FRONT COVER
MAIN FRAME
A) Open HARDWARE BAG FOR STEP 2.
B) Carefully pull the CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C) Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT
WASHERS (C).
D) Attach the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E) Slide CONSOLE MAST BOOT down to seal the console mast hole.
HARDWARE BAG FOR STEP 2 CONTENTS :

LS_645E_Rev.1.7.indd 8-9
CONSOLE MAST
CONSOLE MAST BOOT
TOP BACK COVER
CONSOLE WIRES
ASSEMBLY STEP 
TEFLON WASHERS (F)
FLAT WASHER (G)
BOLT (H)
LINK ARM BRACKET
SPACER (E)
LOWER LINK ARM
PEDAL ARM
A ) Open HARDWARE BAG FOR STEP 3.
B) Align the bracket on the LEFT LOWER LINK ARM with the tube on the LEFT PEDAL ARM.
C) Slide the SPACER (E) through the LINK ARM BRACKET and the PEDAL ARM so it can't rotate.
D) Insert 2 TEFLON WASHERS (F) between the PEDAL ARM and the LINK ARM BRACKET.
E) Secure the joint with a FLAT WASHER (G) and BOLT (H).
F) Repeat on the other side.
HARDWARE BAG FOR STEP  CONTENTS :
SPLIT TEFLON WASHER (F)
30 mm
Qty: 4
BOLT (H)
15 mm
Qty: 2
PEDAL ARM TUBE
SPACER (E)
70 mm axis
Qty: 2
FLAT WASHER (G)
35 mm
Qty: 2

6/25/08 10:43:26 AM