Connecting The Power Cord And Usb Cable; Turning The Scanner On - Kodak i5000 series User Manual

Connecting the power cord
and USB cable
Turning the scanner
on
A-61651 December 2010
After the drivers have been installed, connect the power cord and USB cable
to the scanner. Refer to the illustration below for making proper connections.
Make sure the power outlet is located within 1.52 meters (5 feet) of the
scanner and is easily accessible.
1. Select the appropriate AC power cord for your region from the supply of
power cords packed with your scanner.
2. Plug the output power cord into the power port on the scanner. Be sure it is
securely attached.
3. Plug the other end of the power cord into the wall outlet.
4. Attach the USB cable to the scanner USB port.
5. Attach the other end of the USB cable to the proper USB port on your PC.
1. Press the main power switch on the back of the scanner to the On (I)
position. The LED on the front of the scanner will be a steady yellow and
the Operator Control Panel will be blank (this is low-power mode).
NOTE: It is not necessary to turn the main power switch off unless you
are not going to use the scanner for a prolonged period of time,
you are performing maintenance, you are going to move the
scanner or are directed to turn the power off by Kodak Service.
2-3