Kodak i5000 series User Manual page 38

Changing the print offset
Maximum document length
A-61670 December 2010
The Print Offset function allows you to temporarily move the print location on a
document (e.g., if you need to rescan a document that has already been
printed on).
When you change the print offset position, the change will stay in effect until
the scanner returns to the Idle state.
NOTES:
• The Print Offset option is only displayed on the touchscreen if the printer is
enabled.
• If your scanner is configured to auto start, it is recommended that you
disable autostart if you want to use the Print Offset function for the first
document.
• For more efficient scanning, it is recommended that you set the scanner to
Pause Scanning (in the scanning application) when a multifeed occurs so
the scanner will stay enabled.
• If you set the Print Offset to a dimension that is longer than your document,
there will be no printing on your document.
1. Verify that Printing is enabled in the scanning application.
NOTE: The number displayed on the touchscreen is the additional offset
from what was set by the scanning application. This number is 0 if
the print offset has not been changed.
2. Select Print Offset. The following screen will be displayed.
3. Use the up and down arrows to increment or decrement the print offset
value (in inches or mm). The printing will be incremented/decremented
from the value that is set up in the scanning application. For example, if
you have printing set up to start 1 inch/25 mm from the lead edge of the
document, and you increment the print offset position by 1 inch / 25 mm,
printing will start at 2 inches/50 mm from the lead edge.
4. When finished, click OK.
This option allows you to override the maximum document length that is setup
in the scanning application for the batch. The maximum document length
allowed is variable and dependent on many factors including the output
resolution and format.
3-21