Brother HL-2130 User Manual page 78

Error Message
Out of Memory
Print Unable XX
Replace Drum
Replace Toner
Size Error DX
Toner Ended
Toner Low
52
Cause
The machine's memory is full.
The machine has a mechanical
problem.
It is time to replace the drum unit. Replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
The machine will stop printing
until you replace the toner
cartridge.
The paper in the tray is not a
suitable size for automatic duplex
printing.
It is time to replace the toner
cartridge.
You will need to replace the toner
cartridge soon.
Action
Do one of the following:
 Press Start to copy the scanned pages.
(Copy operation in progress)
 Press Stop/Exit and wait until the other
operations in progress finish, and then
try again.
 Reduce print resolution. (See the Basic
tab in the Software User's Guide.)
Do one of the following:
 Disconnect the machine from the AC
power outlet for several minutes, then
reconnect it.
 If the problem continues, call your
Brother dealer.
(See Replacing the drum unit on page 35.)
Reset the drum unit counter.
(See Resetting the drum counter
on page 39.)
If you have set the Toner setting to Stop,
replace the toner cartridge with a new and
unused original Brother toner cartridge. This
will reset the Replace Toner mode. (See
Replacing the toner cartridge on page 29.)
If you have set the Toner setting to
Continue, the machine will continue to
print data until the LCD shows Toner
Ended. For how to operate the machine in
Continue mode, see Toner Settings in
Chapter 1 of the Advanced User's Guide.
Load A4 paper for automatic duplex printing,
and then press Start. (See Print media
on page 96.)
Replace the toner cartridge with a new one.
(See Replacing the toner cartridge
on page 29.)
Buy a new toner cartridge before you get a
Replace Toner message.