Fan/Heat Sink Assembly - HP EliteBook 2760p Maintenance And Service Manual

5. Lift the right side of the system board, and remove it from the base enclosure (3).
Reverse this procedure to install the system board.

Fan/heat sink assembly

The heat sink spare part kit includes replacement thermal material.
Description
Fan/heat sink assembly
Before removing the fan/heat sink assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Remove the service access cover (see
c. Remove the SIM card (see
d. Remove the memory module (see
e. Remove the hard drive (see
f. Remove the WLAN module (see
g. Remove the WWAN module (see
78 Chapter 4 Removal and replacement procedures
Battery on page 41)
Service access cover on page
SIM on page 45)
Primary memory module on page
Hard drive on page
WLAN module on page
WWAN module on page
Spare part number
649759-001
42)
43)
46)
48)
51)