Top Cover - HP EliteBook 2760p Maintenance And Service Manual

Remove the secondary memory module:
1. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
2. Remove the memory module (2) by pulling the module away from the slot at an angle.
NOTE:
memory module slot.
Reverse this procedure to install a secondary memory module.

Top cover

The top cover kit includes the TouchPad board and capacitive board.
Description
Top cover
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Remove the service access cover (see
Memory modules are designed with a notch (3) to prevent incorrect insertion into the
Battery on page 41)
Service access cover on page
Component replacement procedures
Spare part number
649768-001
42)
57