Display Assembly; Service Access Cover - HP EliteBook 2760p Maintenance And Service Manual

Display assembly

The display assemblies include two WLAN antenna transceivers and cables and two WWAN antenna
transceivers and cables.
Description
30.7 cm (12.1 in) WXGA, LED, AntiGlare touch screen display assembly
30.7 cm (12.1 in) WXGA, LED, AntiGlare touch screen display assembly for use outdoors
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the following components:
a. Remove the battery (see
b. Remove the service access cover (see
c. Remove the WLAN module (see
d. Remove the WWAN module (see
e. Remove the keyboard (see
f. Remove the top cover (see
Remove the display assembly:
1. Position the computer upside down, with the rear toward you.
2. Remove the two Torx 9 M2.0×5.0 screws that secure the hinge cover to the computer.
Battery on page 41)
Service access cover on page
WLAN module on page
WWAN module on page
Keyboard on page 53)
Top cover on page 57)
Spare part number
649753-001
649754-001
42)
48)
51)
Component replacement procedures 63