Call Channel Programming; Adjusting The Volume Level - Icom IC-M36 Instruction Manual

Call channel programming

Call channel is used to access Channel 9 (default), however,
you can program the call channel with your most often-used
channels in each channel group for quick recall.
q Push and hold [CH/WX U/I/C] for 1 sec. several times to
select the desired channel group (U.S.A., International or
Canada) to be programmed. (p. 9)
w Push and hold [16 9] for 1 sec. to select the call channel
of the selected channel group.
• " C ALL" and call channel number appear.
e Push and hold [16 9] again for
3 sec. (until a long beep changes
to 2 short beeps) to enter the call
channel programming mode.
• Channel number starts blinking.
r Push [Y]/[Z] to select the desired
channel.
t Push [16 9] to program the dis-
played channel as the call chan-
nel.
• The channel number stops blinking.

Adjusting the volume level

The volume level can be adjusted with [VOL/SQL MONI]
and [Y]/[Z].
q Push [VOL/SQL MONI] once to enter the volume adjust-
ment mode, then adjust the volume level with [Y]/[Z].
• " V OL" indicator starts blinking.
• The transceiver has 31 volume levels and OFF.
• With no key operation is performed for 5 sec., the transc eiver
returns to the normal condition.
w Push [VOL/SQL MONI] twice to exit the volume adjust-
ment mode.
Blinks while adjusting the volume level.
BASIC OPERATION
Indicates the
volume level.
4
1
2
3
4
.
6
7
8
9
10
11
12
13
14
1.
16
11