Rc-Bm5 - JVC RC-BM5 Service Manual

RC-BM5

Removing the tuner board
1. Remove the wire from the connector H801 on the
tuner board.
2. Remove the two screws P and board holders (B)
retaining the tuner board.
3. Pull out the tuner board from the notches w and x
of the rear cabinet assembly.
4. Remove the FM antenna wire from the soldered
section y on the reverse side of the tuner board.
Removing the cassette deck
mechanism assembly and cassette
board
1. Remove the three screws Q and screw Q' retaining
the cassette deck mechanism assembly.
2. Lift the cassette deck mechanism assembly slightly
and move it as shown in Fig.19.
3. Remove the three screws R retaining the cassette
board.
4. Lift the cassette board slightly, remove the capstan
motor wire and REC/PB head wire from the
soldered sections z and aa on the cassette board.
5. From the forward side of the cassette board,
disconnect the wire from the connector CN602 and
then remove the cassette deck mechanism
assembly.
6. From the forward side of the cassette board,
disconnect the wire from the connector H602 and
then remove the cassette board.
[Notes] When attaching the screw Q', attach the
wire at the same time.
After assembly, apply a locking agent to
the screws Q and Q'.
1-10
(See Figs. 16 and 17.)
(See Fig.17.)
(See Figs. 18 and 19.)
H801
Board holder (B)
Fig.16
Soldered section y
Fig.17
Cassette deck mechanism assembly
Q
Fig.18
Cassette deck mechanism
assembly
R
CN602 (Forward side)
Fig.19
Notch w
Notch x
Tuner board
Board holder (B)
P
Tuner board
(Reverse side)
Wire clamp
Q'
Q
Soldered section aa
R
Cassette board
Soldered section z
R
H602 (Forward side)