Table of Contents
Advertisement
HOW TO DISASSEMBLE AND ASSEMBLE
7. ICEMAKER ASSEMBLY
7-1. Dispenser Model
1) How to disassemble:
(1) Remove ice bank from the freezer compartment.
(2) Loosen two screws on the upper part of Icemaker
bracket.
(3) Disconnect Icemaker bracket so that it can slide
forward.
(4) Disconnect Icemaker housing and sensor housing.
(5) Disconnect Icemaker horizontally by pressing
bracket hook part. ( Don't disassemble further. The
set value may be changed.)
2) How to assemble : The assembly is the reverse order of
the above disassembly.
Bracket, Icemaker
Ice Tray
Sensor
Insulation
Sensor Cover
Note : When the ice tray is not horizontal after assembly,
assembly was performed in correctly. Check and
assemble again.
Hook
Icemaker Unit
Lever
7-2. Basic Model
1) How to disassemble:
(1) Remove ice tray assembly from the freezer
compartment.
(2) Pull out knob from the ice tray in arrow direction.
(At this time, pull out a knob in arrow direction while
shaking right and left as the knob is connected to
pins in A .)
(3) Spring can be removed by pulling ice tray in arrow
direction and pulling out a spring inserted in ice tray
axis from the hole of supporter ice tray.
2) How to assemble : Assembly is the reverse order of
disassembly.
Supporter Ice Tray
Note : It is important to put one end of spring into the hole
of the supporter ice tray and the other end on the
lower part of an ice tray when inserting spring into
the shaft.
- 95 -
Pin
Knob
Ice Tray
Spring
Advertisement
Table of Contents
