Table of Contents
Advertisement
HOW TO INSTALL REFRIGERATOR
3. How to Control the Amount of Water Supplied to Icemaker.
3-1. Verify the amount of water supplied to the Icemaker.
1. Pull out the ice bin in the upper part of the freezer compartment.
2
2. Apply electricity after connecting water pipe.
1) Press test switch under the Icemaker for two seconds as shown below.
2) The bell rings(ding~dong), ice tray rotates, and water comes out from the Icemaker water tube.
3) The water shall be supplied two or three times into the tray. The amount of water supplied for each time is small.
Put a water container under the ice tray and press test switch.
4) When ice tray rotates, the water in it will spill. Collect the spilled water and throw it into the sink.
5) When ice tray has finished rotation, water comes out from the water tube. Confirm the amounts of water in the ice tray.
(Refer to fig. The optimum amount of water is 110cc[6.7in
Confirm the amount
* It is acceptable if the adjusted level of water is a bit smaller than optimum level.
1
of water
Too much
Too small
Caution : • Do not put hands or tools into the chute to
3
])
Optimum level
- 8 -
confirm the operation of geared motor.
(Doing so may damage refrigerator or cause
injury to hands.)
• Check the operation of motor by its
operation noise.
Icemaker
Test Switch
Advertisement
Table of Contents
