Table of Contents
Advertisement
HOW TO DISASSEMBLE AND ASSEMBLE
9. WATER TANK AND WATER LINE
u The water tank at back and lower part of a refrigerator is
attached by one screw and has a capacity containing of
7 glasses (180cc per glass) of cold water. It will take
time to make more cold water in the tank.
* The first portion of dispensed water is not cold even
though the refrigerator is working. In this case,
dispense ice first in the cup and then water to make a
water cold.
Bushing inject
Water supply pipe
3
Water Valve
Connect
Assembly
9-1. How to disassemble the water supply pipe
1) Disconnect five fixtures mounted on the rear wall of the
refrigerator after disconnecting the water supply pipe
from a water valve.
2) Remove the tie-wrap and two screws connected to the
bushing inject.
3) Replace the water supply pipe
water supply pipe
from a rubber inject. And assemble
the parts by performing disassembly in reverse order.
9-2. How to disassemble the water tank and the
water supply pipe
1) Disconnect the water supply pipe
on the back and lower part of the freezer.
2) Disconnect the connector Assembly. in water supply
pipe at lower part of the freezer door.
3) Pull out the water supply pipe
insulation materials after removing one screw and six
tie-wraps in the lower part of a refrigerator compartment.
4) Replace a water tank or a water supply pipe
assemble the parts by performing disassembly in
reverse order.
Note : • The water supply pipe
• Tightly fasten six tie-wraps to prevent leakage.
Water supply pipe
Water Tank
Nut
Tube
2
after disconnecting the
from a water valve
from the thermal
and
cannot be disassembled.
- 97 -
Advertisement
Table of Contents
