Pioneer CDJ-200 Service Manual page 55

5
Track Search F/R
The unit starts searching for the displayed track in the forward or reverse direction and will pause when it finds it.
Error Rate Count
An error rate is measured from the current Play/Pause position for about 10 seconds. The result will be displayed on the FL
display. Normally, search for the track to be measured then press the CUE key in Pause mode. The error rate is displayed,
for example, as "3.56E-4 OK." "OK" is displayed if the error rate is 3.00E-3 or less, and "NG" is displayed if it is more than
3.00E-3. The result is determined on the assumption that the measurement is performed using a control disc upon shipment
of the product. This measurement cannot be used for judging whether or not the product is defective during servicing.
Eject
The loaded disc is ejected.
Mode Change
Press the MASTER TEMPO key during Player Operation mode to change to Test Operation mode. The MASTER TEMPO
LED lights up, and Test Operation mode (described below) is entered.
• Test Operation mode
Servo operations can be controlled step by step in detail.
Please note that incorrect use of commands in Test Operation mode may damage the player.
Servo All Off
When the TIME key is pressed during Servo ON, all the servos will be shut off.
LD On/Off
Pressing the TEMPO key turns the LD ON or OFF.
Focus On/Off
Pressing the RELOOP key during Stop mode turns the LD ON, and auto focusing is performed.
Spindle Kick, Tracking On/Off
When the IN/REAL TIME CUE (LOOP IN) key is pressed while the tracking servo is OFF, spindle kicking is performed, and
the automatic adjustment process and tracking servo are turned ON. When the key is pressed while the tracking servo is
ON, the tracking servo is turned OFF.
Tracking Off
Pressing the (LOOP) OUT key while the tracking servo is ON turns the tracking servo OFF.
Slide FWD
Pressing the SEARCH ¡ (FWD) key while the tracking servo is ON turns the tracking servo OFF and moves the slider
about 2 mm in the forward direction.
Slide REV
Pressing the SEARCH 1 (REV) key while the tracking servo is ON turns the tracking servo OFF and moves the slider
about 2 mm in the reverse direction.
Pickup Up/Down
Pressing the AUTO CUE key during Stop mode turns the LD ON and moves the pickup up and down. Focus will not be
closed.
Mode Change
Pressing the MASTER TEMPO key during Test Operation mode turns the MASTER TEMPO LED off, and Player Operation
mode (described above) is entered.
Note: To start up the servos step by step in Test Operation mode, input the commands in the following order:
Servo All Off, Focus On, Spindle Kick, then Tracking On.
5
6
CDJ-200
6
7
7
8
A
B
C
D
E
F
55
8