Brother HL-1070 Service Manual page 142

Action 5: Plug in and Turn on Your Printer
1
2
3
4
Starter Sheet
Plug the power cord into the AC power
outlet.
NOTE
The shape of the power cord varies
according to the country of destination.
Turn on the power switch that is located on
the left side of your printer.
Make sure that the Ready lamp is lit after
the printer has warmed up (approximately
30 seconds).
Make sure that the printer automatically
ejects the starter sheet while the printer is
warming-up immediately after installing a
new drum unit. You may discard the starter
sheet after it is automatically ejected.
CAUTION
Do not open the top cover until the printer
ejects the starter sheet completely. It may
cause the starter sheet to jam.
- 12 -