JVC HX-C6 Service Manual page 17

3.1.12 Removing the switch board
(See Figs.26 and 27)
• Remove the metal cover, front panel assembly and FL board.
(1) From the front side of the front panel assembly, pull out the
preset knob in the direction of the arrow. (See Fig.26.)
(2) Form the inside of the front panel assembly, remove the six
screws U attaching the switch board. (See Fig.27.)
(3) Take out the switch board from the front panel assembly
and disconnect the card wire from the connector
the forward side of the switch board. (See Fig.27.)
3.1.13 Removing the volume and jack boards
(See Figs.26 and 28)
• Remove the metal cover and front panel assembly.
(1) From the front side of the front panel assembly, pull out the
volume knob in the direction of the arrow. (See Fig.26.)
(2) Disconnect the card wire from the connector
volume board. (See Fig.28.)
(3) Form the inside of the front panel assembly, remove the
ten screws U attaching the volume and jack boards. (See
Fig.28.)
(4) Take out the volume board with the jack board from the
front panel assembly.
Reference:
When removing the jack board from the volume board, remove
the soldered sections p on the jack board as required. (See
Fig.28.)
FW201 on
FW301 on the
Volume knob
FW201
Volume board
FW301
U
Preset knob
Front panel assembly
Fig.26
U
Fig.27
Jack board
Fig.28
U
Switch board
U
U
p
(No.MB366)1-17