Setting The Tv; Setting The Channels - Sony KE-42M1 Service Manual

Setting the TV

Setting the Channels

After you finish connecting your TV, you can run
Auto Program to set up your channels. The Auto
Setup menu appears when you turn your TV on for
the first time after installing it.
To skip channels, see page 36.
DVD/ SAT/ POWER
MUTING VCR CABLE
MODE
PICTURE WIDE SLEEP DISPLAY
FREEZE FAVORITES MENU
TOP MENU
F1
F2
TV VIDEO 1/2/3 VIDEO 4 VIDEO 5
RESET PIC OFF MTS/SAP
GUIDE TV/SAT
1
2
Auto Program is set to scan cable TV channels by
default. To watch VHF/UHF channels with an
1
antenna, see "To watch VHF/UHF channels with an
antenna" on page 36.
To perform Auto Program again
1
2
3
4
5
To cancel Auto Program
While "Auto Program" is displayed in step 3, press
MENU on the remote control.
Note
To watch cable TV channels, you have to subscribe to a cable
TV company. Note that cable TV cannot be received in some
areas. This TV receives 1-125 cable TV channels. For details on
2
cable TV subscription, consult your nearest cable TV company.
Press 1 (Power) on the TV.
The Auto Setup menu automatically appears on
the screen when you turn on the TV for the first
time.
Auto Setup
,
Press CH + on the remote control or on the drop-
down panel of your TV to perform Auto
Program.
When all the receivable channels are stored, the
"Channel Skip/Add" menu appears.
Press MENU.
Press V/v to select
(Channel), then press
.
Press V/v to select "Auto Program," then press
.
Press .
"Auto Program" appears and the TV starts
scanning and presetting channels automatically.
When all the receivable channels are stored, the
"Channel Skip/Add" menu appears. Using this
menu, you can start skipping unnecessary
channels (see "To skip channels" on page 36).
Press MENU to exit the menu screen.
Auto Program: [CH+]
Exit: [CH–]
First please connect
cable/antenna
(Continued)
35