Removing The Interface Unit Assembly - Epson ELP-3500 Service Manual

3.2.12 Removing the Interface Unit Assembly

Prerequisite: Complete the steps explained in sections 3.2.1 and 3.2.4.
1. Remove the GND cable mounting screw.
Screw:
2. Remove 2 interface unit assembly mounting screws.
Screws:
3. Remove the fan holding plate mounting screw.
Screw:
4. Slide the interface unit slightly inward so it does not contact the frame, before
removing it.
Caution:
When installing the interface board assembly, align the 2 positioning holes (beside the
screw holes) in the board with the bosses on the bracket before tightening the screws.
Figure 3-21.
+M3x6 F/Ni: P/N 1033122
Mounting torque: 6.0 kg cm = 5.2 lb inch
+M3x8 F/Zn P-Tight: P/N1021824
Mounting torque: 6.0 kg cm = 5.2 lb inch
+M3x6 F/Ni : P/N1033122
Mounting torque: 6.0 kg cm = 5.2 lb inch
EPSON ELP-3500 Service Manual
Ground Cable Screw
Screws
3-18