Table of Contents
Advertisement
Make sure the requirements below are met
when installing the printer. The service
engineer should inspect the place lhe
printer will go before delivery.
1. Power supply
Line vollage: No more than 2 10% outside
l
the rated voltage
Line frequency: SO/60 + 2 Hz
l
2. Operatinn
conditions
Flat level. supporting surface
Ambient temperature of 10 lo 325°C
Humidity of 20 to 80% KH
No condensation
Good ventilation
not install the printer in these places:
Do
.
the sun
In
If the printer must go somewhere sunny,
the windows must have curtains keep to
the sun off.
.
Near magnets or equipment that produces
a magnetic field
.
Where there is vibration
.
Where it is dusty
.
Near flames or water
J. Installation apace
There must be an enough space around the
printer to operate it. (See Figure 4-l) The
printer must go on a desk or other level
surface large enough to accommodate its
feet (and those
used) and sturdy
weight
.
Figure 4-l
CHAPTER 4
of the paper feeder, if
enough lo carry its
4-l
Advertisement
Table of Contents
