Table of Contents
Advertisement
2. Removing the paper feeder pick-up
motor
1) Kemove the drive unit.
2) Remove the four screws, the E-ring, the
gear, and remove the plate.
Screws
Cl)
a Gear
Figure 5-77
3) Remove the Iwo screws and remove the
pick-up motor.
@
Screws
figure 3-78
@> E-ring
(4) Plate
QI Pick-up motor
Removing the paper feeder driver
PCB
Remove the screw. release the two
claws, and open lhe PCB cover.
Fig. 3-75.)
Disconnect the three connectors and
remove the cable tie.
Release the claw holding the PCB, then
lift the paper feeder driver PCB.
0 Claw
@I Paper feeder driver PCB
Figure
4. Removing the paper feeder pick-up
roller
I]
Pull out the pick-up roller by its knob.
0 Pick-up roller
Figure 3-80
CWAFTER 3
[See
3-79
3 - 29
Advertisement
Table of Contents
