Table of Contents
Advertisement
Paper Pick-up Unit
Removing the paper pick-up unit
&IWJV~
the cassette.
Kcrnc~ve lhr inner cover.
Kemovr the upper rover unit.
I
Kernwe
he leli cover.
Kemovc the multi-purpose tray.
I
Kemovr
hr control panel unil.
Kemavc the three screws from the left
side trl LhP prinler.
Figure 3-18
8) &move
the two screws, disconnect the
two connectors, and pull the paper
pick-up unit forward and out.
Srrews
2 Connertors
(1)
(31 Paper pick-up unit
Figure 3-19
Note:
If' you
replace the paper pick-up
unit. make several test prints and
cherk the leading edge registration
is 2.0 mm. II it is not, adjust il.
(See page 6-9)
Disassembly and reassembly
2.
a.
Pick-up motor
Disconnect the connector, remove the
1)
two screws. and rem"ve the pick-up
motor.
0 Connector
(Z Screws
0 Pick-up motor
Figure
CHAPTER 3
3-20
3-7
Advertisement
Table of Contents
