B. Video Controller PCB
I) Kanove lhr right cover.
2) Rcrnovr ihe four screws and then the
shield case.
(2' Shield case
3) Screws
Figure 3-49
3) II' an expansion ROM PCB is installed.
the
PCB should be rcmovcd
41
IT the RAM SIMM is installed. the SIMM
should be removed.
5) Disconnect the connector. (If an optional
hard disk drive is installed. lwo
connectors should be disconnected.)
Then, remove the four screws and video
controller PCB.
0 Expansion ROM PCB
@ RAM SIMMs
:31 Connectors
(4: screws
G Video controller PCB
Figure 3-50
Note for assembly
If you removed the expansion ROM PCB or
RAM SIMM when you replaced the video
controller PCB. reinstall it on the new video
controller PCB.
CHiUTER 3
3-19