Initializing Settings - Buffalo TeraStation III iSCSI TS-IXL User Manual

Initializing Settings

Reset Button
To reset the TeraStation's settings to factory defaults, use the included key to open the front cover to access the reset
button. While the TeraStation is running and the power LED is lit, hold down the reset button until it beeps (about 5
seconds). This will reset the TeraStation's settings to the factory default.
Hold down the reset button until it beeps (about 5 seconds). This will reset the TeraStation's settings to their factory de-
faults.
TS-IXL
Reset Button
• The reset button initializes the following settings: IP address, Ethernet frame size, admin username and password, port
trunking (initial setting: disabled), iSCSI HDD Connection Tool detection (initial setting: enabled). Other settings can be
initialized from Settings (page 40).
• To keep the current username and password when initializing the TeraStation, navigate to Maintenance - Restore/Erase-
Restore Factory Defaults - Modify Settings in Settings and select Keep current admin password. Click Save.
If you disable resetting the admin password from the reset button, you can no longer configure the TeraStation if you
forget the password. Write down your password and keep it in a safe place.
TeraStation III iSCSI User Manual
TS-RIXL
To press the reset button on the TS-RIXL series, use the tip of an unfolded paper
clip.
Reset Button
39