Not Registered; Out Of Memory - Brother MFC-J200 User Manual

Error Message
No Response/Busy

Not Registered

Out of Memory

Paper Jam
Cause
The number you dialled has not
answered or is busy.
You tried to access a Speed Dial
number that has not been stored in
the machine.
The machine's memory is full.
The paper is jammed in the machine. Remove the jammed paper by
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Troubleshooting
Action
Verify the number and try again.
Set up the Speed Dial number. (See
Storing Speed Dial numbers
on page 36.)
If a fax-sending or copy operation
is in process:
 Press Stop/Exit and wait until the
other operations that are in
process finish, and then try again.
Press Mono Start or

Colour Start to choose Send to
send the pages scanned so far.
 Press Mono Start or
Colour Start to print the pages
scanned so far.
Clear the data in the memory. To

gain extra memory, you can turn
off Memory Receive.
(See Advanced User's Guide:
Turning off Memory Receive
operation.)
 Print the faxes that are in the
memory. (See Advanced User's
Guide: Printing a fax from the
memory.)
following the steps in Printer jam or
paper jam on page 65.
Make sure the paper length guide is
set to the correct paper size.
If there is a repeat paper jam, a small
piece of paper may be stuck in the
machine. Make sure paper is not still
jammed in the machine. (See
Additional paper jam clear operations
on page 68.)
Clean the paper pick-up rollers.
(See Advanced User's Guide:
Cleaning the paper pick-up rollers.)
B
61