Brother MFC-J200 User Manual page 102

Level1 Level2
5.Network 4.WPS/AOSS
(Continued)
5.WPS w/PIN Code —
6.WLAN Status
7.MAC Address
8.WLAN Enable
0.Network Reset
See Software and Network User's Guide.
The default settings are shown in Bold with an asterisk.
Menu (continued)
Level1 Level2
6.Print Reports 1.XMIT Verify
2.Address Book —
3.Fax Journal
4.User Settings
5.Network Config —
6.WLAN Report
7.Machine Info. 1.Serial No.
2.Version
See Advanced User's Guide.
See Quick Setup Guide.
The default settings are shown in Bold with an asterisk.
94
Level3 Options
— —
—
—
1.Status
—
2.Signal
—
3.SSID
—
4.Comm. Mode
— —
—
On
Off*
— —
Level3 Options
— —
—
— —
— —
—
— —
— —
— —
Descriptions
You can easily configure
your wireless network
settings using the one-
button push method.
You can easily configure
your wireless network
settings using WPS with
a PIN code.
You can see the current
wireless network status.
You can see the current
wireless network signal
strength.
You can see the current
SSID.
You can see the current
Communication Mode.
You can see your
machine's MAC address
from the control panel.
Lets you use the wireless
network connection.
Restores all network
settings to the factory
default.
Descriptions
Prints these lists and
reports.
Lets you check the serial
number of your machine.
Lets you check the
firmware version of your
machine.
Page
See .
C
Page
See .
85