Advertisement
3. From outside of door, position the exterior escutcheon by first routing the wire
harness through 2-1/8" diameter hole and under the latch (Fig. 4 & 5), then
inserting the through posts* and tailpiece/square drive tube into the latch (Fig. 5).
4. Remove the interior mounting plate (with gasket) from the back (door side) of the interior
escutcheon (Fig. 6).
Interior Escutcheon & Mounting Plate
5. Remove the battery cover from the back of the interior escutcheon (Fig. 8) by
loosening the captive Phillips head screw, then lifting the cover up and out.
Note tabs at bottom of cover.
An ASSA ABLOY Group brand
Exterior of Door
Figure 4
Figure 6
(with gasket)
Figure 8
Interior of Door
Tailpiece
horizontal
NOTE: Wire harness goes
under latch (Fig. 4 & 5).
*
Posts are inserted in holes according to
backset adjustment. (Refer to Fig. A under
"Lock Preparation")
A. Ensure that gasket on
interior mounting plate
is properly fitted (Fig. 7).
"Top" of Drive Tube
(marked BLACK)
Figure 5
Figure 7
P/N AYRT-220-INST-FUL Rev B
7
Advertisement
