Changing The Dialling Mode/ Flash Time; Operation On Public Telephone Systems; Contact With Liquid; Questions And Answers - Gigaset DA310 User Manual

Changing the dialling mode/
flash time
The telephone supports the follow-
ing dialling modes:
T2: Tone dialling, flash time 280 ms
T1:Tone dialling, flash time 100 ms
P: Pulse dialling
Depending on your PABX, you may
need to change your telephone's
dialling mode or the flash time.
To do this, use the slid-
ing switch on the
underside of the
device.
Temporary tone dialling switching
in "Pulse" position
To use functions that require tone
dialling (e.g. remote control of
answering machine), you can set the
telephone to tone dialling for the
duration of the call without adjust-
ing the switch.
*
After the connection is established:
Press the star key.
After the connection is broken, the
setting reverts to pulse dialling.
Operation on public
telephone systems
Public telephone systems - in some
cases by special order/request – offer
you a range of useful additional serv-
ices (e.g. call divert, call back on busy,
three-party conference etc.). These
services can be selected using speci-
fied key combinations, which your
network provider will notify you of.
You can save the entire key combina-
tion, including the number of a fixed
call divert destination, to your pro-
grammable direct dial keys or speed
dial keys just like a normal number.
5
en

Recall key

In public telephone systems, the
recall key is required to use certain
additional services; e.g. for "Call back
on busy".
You may need to adjust the flash
time of your telephone to the needs
of the public telephone system. To
do this, use the sliding switch on the
£
underside of the
telephone(
Appendix
Care
Wipe the unit with a damp cloth or
an antistatic cloth. Do not use sol-
vents or microfibre cloths.
Never use a dry cloth; this can cause
static.

Contact with liquid

If the device comes into contact with
liquid:
1 Allow the liquid to drain from the
device.
2 Pat all parts dry. Place the device
(the keypad facing down) in a
dry, warm place for at least 72
hours (not in a microwave, oven
etc.).
3 Do not switch on the device
again until it is completely dry.
When it has fully dried out, you will
normally be able to use it again.
In rare cases, contact with chemical
substances can cause changes to the
telephone's exterior. Due to the wide
variety of chemical products availa-
ble on the market, it was not possible
to test all substances.

Questions and answers

You lift the handset but you hear
no dialling tone: Is the connecting
lead correctly plugged into the tele-
phone and the telephone socket?
The dialling tone is audible but the
telephone will not dial: The con-
page 5).
!