Configuration Procedure - Huawei S3700 Series Quick Start Manual

S3700&S5700&S6700 Series Ethernet Switches
Quick Start
Networking Requirements
As shown in
connected through a trunk link. To enable the network administrator to manage SwitchA
remotely, you need to configure the Telnet service and set the device name on SwitchA.
Figure 5-5 Networking diagram of managing SwitchA through Telnet
RS-232
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l

Configuration Procedure

1.
Issue 02 (2012-09-10)
Figure 5-5, SwitchA is newly added to the network. SwitchA and SwitchB are
administrator
serial port Console port
Console cable
PC
Log in to SwitchA through the console interface.
Set the device name.
Configure a management VLAN.
On SwitchA, set the type of the interface that connects SwitchA and SwitchB to trunk. Add
the interface to the management VLAN in trunk mode.
Configure the management IP address of SwitchA.
Configure the Telnet service.
ID of the management VLAN
Management IP address of SwitchA
Number of the interface that connects SwitchA and SwitchB on SwitchA
Authentication mode, user name, and password
Log in to SwitchA through the console port. For details, see
Through the Console
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Ethernet
SwitchB
GE 0/0/1
GE 0/0/1
SwitchA
Interface.
5 Logging in to the Device
Logging In to the Switch
59