Siemens ERTEC EB 200 Manual page 3

Preface
Contents of this Manual
Detailed description of the individual function groups of the EB 200

Connector pin assignment and jumper assignment

Target Audience of this Manual
This manual is intended for hardware developers who want to use the ERTEC 200 for new products. Experience
working with processors and designing embedded systems and knowledge of Ethernet are required for this.
The manual serves as a reference for software developers. Sections 7 and 8 describe the jumper settings and
connectors that are required for software tests (e.g., debugging, terminal outputs, etc.).
Structure of this Manual
This manual describes the ERTEC 200 evaluation board. The manual is structured as follows:
Section 1 Introduction
o
Section 2 Hardware Structure of the EB 200
o
Section 3 Memory Distribution of the EB 200.
o
Section 4 Operating Modes of the EB 200
o
Section 5 JTAG Interface of the EB 200
o
Section 6 Settings of the EB 200
o
Section 7 Connectors of the EB 200
o
Section 8 Jumpers of the EB 200
o
Section 9 Mechanical Structure of the EB 200
o
Section 10 List of Terms and References
o
When working with modules, always take precautionary measures against electrostatic charge
(ESD – Electrostatic Sensitive Devices).
For module handling and installation, refer to /3/.
This manual will be updated as required. You can find the current version of the manual on the Internet at
http://www.siemens.com/comdec
Copyright © Siemens AG 2010. All rights reserved.
Technical data subject to change
.
Page 3
EB200 Manual
Version 1.1.4