Connect To The Internet - BAYweb BW-WT2 Owner's Manual

4

Connect to the Internet

The BAYweb Thermostat is factory configured for system type 3, conventional one
heat/one cool. This will also work for system types 1 and 2. If you have a multistage
furnace, air conditioner, or heat pump, you will need to connect the thermostat to the
Internet and configure it for the type of system that you have prior to use.
A) Connect the Control Module to the Internet. Plug one end of an Ethernet cable into the
LAN port on the bottom of the Control Module and the other end into a port on a router
or switch on your local network.
B) If direct wiring is not convenient, use Power Line Ethernet adapters. Plug one adapter
into a power plug near the control module and the other adapter near your router. Then
just plug the Ethernet cables into the adapters and the ports.
C) The BAYweb Thermostat does not require any configuration or programming of your
networking equipment. You do not need to change security settings. Just plug it in and
you are all set to go.
D) Plug in the control module. Do not power up your furnace, air conditioner, or heat pump
yet. The Power LED on the control module should illuminate.
E) In less than a minute the "Uplink" light should illuminate on the control module. If you
do not see "Uplink" light up within a couple of minutes, refer to the Troubleshooting
section of this manual.
11