Install Thermostat Keypad - BAYweb BW-WT2 Owner's Manual

3

Install Thermostat Keypad

A) Remove the wires from your existing thermostat, taking care that the wires do not fall
back into the wall.
B) Remove the existing thermostat and any associated mounting hardware.
C) Fill in any holes from the previous thermostat mounting and paint the wall if needed.
D) Hold the Thermostat Keypad in the desired position and mark the location of the
mounting screws. Drill 3/16 inch holes and install the supplied wall anchors. Note that if
your thermostat was installed using an electrical box, the keypad will mount directly to
a standard electrical box using the supplied screws.
E) Make sure the ends of each wire are stripped and ready to be attached to the new
Thermostat Keypad. If any wires break off then use your wire stripper to strip
approximately ¼ inch of insulation from the end of the wire.
F) Using the supplied wire nuts, attach the four colored wires coming from the Thermostat
Keypad (red, white, green, yellow) to the four matching colored wires from the cable in
the wall. If your installation uses non standard wire colors, use the table you completed
in step 1C to connect your wire colors to the standard color of the Thermostat Keypad.
G) If you have any spare wires not being used, cut off any bare sections and ensure that
they will not short to anything in the Thermostat Keypad.
H) Push the thermostat cable into the wall to remove as much slack as possible. Fit any
excess wiring into the space behind the Thermostat Keypad.
I) Attach the Thermostat Keypad to the wall using the supplied screws.
10