BAYweb BW-WT2 Owner's Manual page 12

E) Connect the wiring going to the furnace, air conditioner, or heat pump:
Attach the wires in the cable coming from the furnace to the terminals on the RIGHT
side of the control module labeled "Furnace/AC". Be sure to match the wire color and
terminal designation as identified in Step 1.
NOTE: If your system uses separate Rh and Rc wires, be sure to remove the jumper
wire between the Rh and Rc terminals. If your system uses a single Red wire, make
sure the jumper wire between terminals Rh and Rc is installed.
CAUTION: It is very important to connect the thermostat cable to the correct
! connectors on the Control Module.
"Thermostat" connector to your furnace or air conditioner wiring, the
control module will be damaged.
F) Confirm that the terminal screws are tight, the wires will not pull out of the terminals,
and that there are not any shorts between terminals.
If you connect the control module
9