Table of Contents
Advertisement
Post Event Flags
Device Macro
Flags
Rev. B
CCTV Keyboards
Selecting the POST EVENT FLAGS field allows for selecting the type of
events that will trigger the POST EVENT MACRO. Click on a selection field to
toggle selecting and deselecting an event that will trigger the Post Event
Macro. The possible events are described below.
Monitor Select – the post event macro is executed every time a monitor is
selected.
Source Select – the post event macro is executed every time a vide input
device is selected.
Source Changed – the post event macro is executed every time a different
video input device is selected on the keyboard's current monitor.
PTZ Control – the post event macro is executed every time the keyboard is
used for control of a pan / tilt camera.
VCR Control – the post event macro is executed every time the keyboard is
used for control of a VCR.
All keys – the post event macro is executed for every key press on the
keyboard.
To select or deselect all events, click on the Select All or Deselect All button.
When done selecting events, click on the OK button.
To exit the field without changing the current selections, click on the Cancel
button.
This field allows for definition of the default cold boot state of the macro flags
for the current keyboard.
These macro flags can be set, cleared and tested from within the macro
programming environment. They are not normally used and would usually be
left blank. Click on any field to toggle its state. A checked field indicates the
macro flag is set TRUE. Click on the 'All' button to toggle the state of all
macro flags. When done setting the macro flags, click on OK. To leave the
macro flags dialog box with making any changes, click on Cancel.
6-26
HMXMC001013
31-Mar-06
Advertisement
Table of Contents
