Enabling Or Disabling Scan Mode; Viewing And Disconnecting User Connections - Avocent DSR Installer/User Manual

40 DSR® Switch Installer/User Guide
4. From the user station, type the information and perform the mouse movements you wish to
broadcast.
To turn Broadcasting off:
From the Commands dialog box, clear the Broadcast Enable checkbox.

Enabling or disabling Scan mode

To start the Scan mode:
1. If the OSCAR interface is not open, press
2. Click Commands to open the Commands dialog box.
3. Select Scan Enable in the Commands dialog box.
4. Click X to close the Commands dialog box.
NOTE: Scanning will begin as soon as the Scan Enable button is selected.
To cancel Scan mode:
Select a target device if the OSCAR interface is open.
-or-
Move the mouse or press any key on the keyboard if the OSCAR interface is not open.
Scanning will stop at the currently selected target device.
-or-
From the Commands dialog box, deselect the Scan Enable checkbox.

Viewing and disconnecting user connections

You can view and disconnect users through the User Status dialog box. The username (U) will
always be displayed; however, you can display either the target device name or EID number to
which a user is connected. If there is no user currently connected to a channel, the user field
will be blank and the Server Name field will display Free.
To view current user connections:
1. If the OSCAR interface is not open, press
2. Click Commands - User Status to open the User Status dialog box shown in Figure 3.19.
to open the Main dialog box.
Print Screen
to open the Main dialog box.
Print Screen