Figure 3.11: Scan Dialog Box; Using Scan Mode - Avocent DSR Installer/User Manual

To turn Broadcasting off:
From the Commands dialog box, clear the Broadcast Enable checkbox.

Using Scan mode

In Scan mode, the DSR switch automatically scans from port to port (target device to target
device). You can scan up to eight target devices, specifying which ones to scan and the number of
seconds that each will display. The scanning order is determined by placement of the target device
in the list. The list is always shown in scanning order. You can, however, choose to display the
target device's name or EID number by pressing the appropriate button.
NOTE: Scanning is only available to the local user.
To add target devices to the Scan list:
1. If the OSCAR interface is not open, press
2. Click Setup - Scan. The Scan dialog box appears.

Figure 3.11: Scan Dialog Box

3. Determine the order within the list to add the target device. If there are no target devices in the
Scan list, your cursor will appear in a blank line at the top of the list.
-or-
To add a target device to the end of the list, place your cursor in the last target device entry and
press the
Down Arrow
-or-
To add a target device within an existing list, place your cursor in the line below where you want
to insert a new target device and press
Print Screen
key.
.
Insert
Chapter 3: Local Port Operation
. The Main dialog box will appear.
27