Activating The Auto Power Off Function - Yamaha POCKETRAK W24 Reference Manual

Flashing the recorder's LED indicator:
You can set the recorder so that its recording/playback LED indicator (located in the upper
part of the recorder) will flash green when the recorder receives a signal from the remote
control.
After flashing green for a few seconds, the LED indicator will light up steadily or turn off,
depending on the [REC/PLAY LED] setting, as explained in the "Changing the LED setting"
on page 25.
2.
Press the [VOL +/–] buttons to select [LED], then press the [MENU/ENTER] button.
3.
Press the [VOL +/–] buttons to select [ON], then press the
[MENU/ENTER] button.
To make the LED indicator not flash green, select [OFF].

Activating the Auto Power Off function

If this function is turned on, and you leave the recorder turned on but unused for a specified
duration, the recorder will automatically turn off (except during recording, VAS recording
standby mode, playback or metronome operation).
1.
Press the [MENU/ENTER] button for at least two (2) seconds
while the main screen is displayed, press the [VOL +/–] buttons to
select [COMMON MENU]  [AUTO OFF], then press the [MENU/
ENTER] button.
2.
Press the [
function the Auto Power Off, then press the [MENU/ENTER]
button.
0 (OFF)–15 (15 min.)
You can specify the time in 1 minute steps.
To cancel the Auto Power Off function, specify [0](OFF).
POCKETRAK W24 Reference Manual
]/[ ] buttons to select the desired time to
11
Preference Settings
33
LED
OFF
ON
33
COMMON MENU
AUTO OFF
BACKLIGHT
CONTRAST
RECYCLE BIN
FORMAT
33
AUTO OFF
15 min
0 15
60