Sensor - Ness IQ-MDVR-4 User Manual

Ness IQ-MDVR-4 – Mobile Black Box Recorder.

6.4.1 SENSOR

The Ness IQ-MDVR-4 can support 8 sensor inputs.
ENABLE: Enables the input to be active on the sensor
NAME: Press ENTER to move to the Name field to display the soft keyboard. Enter the text name to identify the
source of each Sensor connected to the unit.
OSD:
Input the numbers and Characters, they will be shown on screen when alarms happen, and the alarm
information will be embedded into the video file. Press【Enter】 into the soft keyboard. The label also
identifies the type of event when doing a quick search using EVENT SEARCH option.
SET: LOW (normal close) means low voltage will trigger the alarm.
HIGH (normal open) means a higher voltage will trigger the alarm.
ALARM: Press ENTER to select between OFF or ON:
ON means when the sensor is triggered the alarm LED will flashing until re-logging in with a system
with account to reset the alarm.
LOCK: When LOCK is set ON, the video file will not be over written during the over-write process of the hard
If switch/alarm/lock are all set as ON, when the sensor is triggered it will trigger alarm signal and
the event log. It will also trigger alarm recording and event recording.
NEXT PAGE:
The sensor trigger action means setup of alarm linkage for each sensor. For example, you setup
the ch1 as the alarm linkage for sensor1, when sensor1 triggered, ch1 will change to full screen. And the devices
will response the trigger by PRI, sensor1 has the highest priority, sensor8 has the lowest priority.
disk;
42
User Manual