Assembly; Dealer Set-Up Instructions - Honda RM752A Operator's Manual

Be familiar with all safety practices on pages
5.
Make certain a l l movement of cutter
components has stopped before openlng
blade access cover.
Always wear relatively tight and belted
clothing to avoid entanglement
parts. Wear sturdy, rough-soled work shoes
and protective equlpment for eyes, hands,
hearlng and head.
a t
Operate PTO 2,000 rpm maxlmum.
Turn tractor engine off, remove key, lower
mower to ground before performing any
or
Block mower securely before working under-
neath.
Keep all persons away from operator control
area whlle perfonnlng adjustments, senrlce
or malntenance.
Make sure tractor PTO sprlng-activated
In mower drlvellne spline groove.
Removing Mower From Box
Remove mower components from the comer fillers.
Remove lag screws from crating brackets on both
sides of the mower. Remove mower frame from

DEALER SET-UP INSTRUCTIONS

Assembly of this mower is the responsibility of the
dealer. It should be delivered to the owner
completely assembled, lubricated and adjusted for
normal mowing conditions.
Complete check list on page
complete.
F-7756

ASSEMBLY

and
4
moving
I s
seated
when assembly is
3
9
The mower is shipped partially assembled.
Assembly will be easier if components are aligned
and loosely assembled before tightening hardware.
Recommended torque. values for hardware are
located on page
'8.
Select a suitable working area. Lay parts and
hardware out to make location easy. Refer to
illustrations, accompanying text, parts lists and
exploded view drawings.
and
Left Side Skid
(figure
1)
NOTE: To make installation easier, put blocks
under the mower frame to raise it off the floor.
The left side shield (7) and skid
guards. Do not operate mower unless they are in
place and in good condition.
Attach left side shield (7) to mower frame (5) as
shown with bolts
and flange locknuts
(1)
Attach left side skid
(6)
shown with bolts lockwashers
Do not tighten this hardware as the skid will require
adjustment when cutting height is set.
x Bolt
1. 318 1"
Lockwasher
2 .
Hex nut
3. 3/8"
Flanged locknut
4. 318"
5. Mower frame
Left side skid
6.
7. Left side shield
Figure Left Skid
1.
Installation
Shield
also sewe as
(6)
(4).
to (5) as
and nuts
(2) (3).
Shield Installation