Honda RM752A Operator's Manual page 27

2. With snap rings removed, support drive in vise,
hold yoke in hand and tap on yoke to drive cup out
of yoke. See figure
20.
Figure 20
3 . Clamp cup in vise as shown in figure
on yoke to completely remove cup from yoke.
Repeat steps
two and three
Figure
F-7756 (1 0-89)
and tap
21
for opposite cup.
21
Place universal cross in vise'as. shown in figure
4.
and tap on yoke
22
three for final removal. Drive remaining cup out with
drift and hammer.
Assembly
Place seals securely on bearing cups. Insert
1.
cup into yoke from outside and press in with hand
pressure as far as possible. Insert journal cross into
bearing cross with grease fitting away from shaft.
Be careful not to disturb needle bearings. Insert
another bearing cup across from first cup and press
in as far as possible with hand pressure.
Trap cups in a vise and apply pressure. Be sure
journal cross is started into bearings and continue
pressure with vise, squeezing in as far as possible.
Tap yoke to aid in process.
2. Seat cups by placing a drift (slightly smaller
than the cup) on cup and rapping with hammer.
(See figure 23.) Install snap ring and repeat on
opposite cup.
25
remove cup. Repeat step
to
Figure 22