Honda RM752A Operator's Manual page 12

Front Corner Baffle Installation
Attach front corner baffle (5) up under mower frame
as shown and attach with bolts (8) and flange lock-
nuts
(9).
Ensure both slde skids, the left side shield and
elther the dkcharge chute
are installed.
Right Side Shield & Baffle Installation
(flgure 2)
INSTALLATION
INSTALLATION
frame
1. Mower
2. Right side skid
3. Discharge chute
4. Right side shield
5. Front corner baffle
6. Side shield baffle
7. 3/8 x 1" Bolt
8. 3/8 x 3/4" Carriage bolt
9.
10. 3/8" Lockwasher
11. 3/8" Hex nut
Figure 2. Right Skid, Shield & Discharge Chute
(figure 2)
or
rlght slde shleid
FRONT CORNER
INSTALLATION
10
When right side shield
(4)
install side shield baffle
baffle to mower frame with bolt (8) and flange
(6)
locknut as shown. Attach front end of baffle
(9)
to side shield with bolt (8) and flange locknut
(4)
as shown. Attach side shield
with bolts and flange locknuts
(7)
Discharge Chute Installation
The discharge chute (3) may be installed
baffle and side shield (4). Attach discharge chute
(6)
(3) to right side of mower with
locknuts as shown.
(9)
Right Side Skid Installation
The right skid (2) also serves as a guard. Do not
operate mower unless it is in place and in good
condition.
Attach right side skid (2) to mower frame (1) as
bolts
shown with
Do not tighten this hardware as the skid will
(11).
require adjustment when cutting height is set.
Caster Arm Installation
1. Mower frame
Caster arm
2.
3. Adjustment bracket
4. 1/2
X
5. 1/2 x 1-3/4" Carriage bolt
Flanged hex locknut
6. 1/2"
Figure 3. Caster Arm Installation
is installed, you must
Attach rear portion of
(6).
(6)
(9)
to mower frame
(4)
as shown.
(9)
(figure 2)
in place of
bolts
(7) and flange
(figure 2)
(figure
F-7756 (1 0-89)
I