Finish Assembly; Description Of Controls - Honda HRE330 Operator's Manual

3. FINISH ASSEMBLY

WARNING!
Unpacking and completing the assembly
should be done on a flat and stable surface, with enough space
for machine handling and its packaging, always making use of
suitable equipment.
Disposal of the packaging should be done in accordance with the
local regulations in force.
Insert the lower part right
(1) and left (2) of the handle
into the respective holes
and lock into position with
the supplied screws (3).
Attach the upper part of the
handle (4) to the lower part
using the knobs (5) and the
supplied nuts and bolts as
shown.
Attach the cable-clamp (6)
to the position shown and
then attach the cable (7).
The correct position of the
electric cable hook (8) is as
shown.
Insert the frame (1) into the
sack (2) and attach all the
plastic profiles (3) with the
help of a screwdriver, as
shown in the drawing.
To attach the wheels, follow
the steps shown.
Attach the wheels selecting
one of the holes for the pre-
ferred cutting heights, fully
tightening the pin (1) using
the wrench (2) provided.
EN 4

4. DESCRIPTION OF CONTROLS

The motor is controlled by a
dual action switch to prevent
starting it accidentally.
To start, press the button (2)
and pull the lever (1).
The motor automatically
stops on releasing the lever
(1).
The cutting height is adjusted by attaching the wheels to the re-
quired hole, fully tightening the pin (1) using the wrench (2) pro-
vided.
All the wheels must be at the same height.
MAKE THIS ADJUSTMENT ONLY WHEN THE BLADE IS
STOPPED.