Trouble Shooting; Mowing Conditions - Honda RM752A Operator's Manual

Problem
Grass cut lower in center
of swath than at edge
Streaking conditions in
swath
Material discharges from
mower unevenly;
bunches of material along
swath

TROUBLE SHOOTING

MOWING CONDITIONS

Possible Cause
Height of mower lower at rear
or front
Conditions too wet for mowing
Blades unable to cut that part
of grass pressed down by
path tractor tires
of
Dull blades
Material too high and too
much material
Grass wet
Rear of mower too low, trap-
ping material under mower
28
Solution
Adjust mower height and attitude so that
mower rear and front are within 1/2" of
same height. See instructions on page 14.
grass to dry before mowing.
Allow
Slow ground speed of tractor but keep
engine running at full PTO rpm. Cutting
lower will help.
Sharpen or replace blades.
Reduce ground speed but maintain 2,000
rpm at tractor PTO, or make
over material. Raise the mower for the first
pass and lower to desired height for the
second and cut at 90" to first pass. Raise
rear of mower high enough to permit mate-
rial to discharge, but not so high that condi-
tions listed above occur.
Allow grass to dry before mowing. Slow
ground speed of tractor but keep engine
running at full PTO rpm. Cutting lower will
help.
Adjust mower height and attitude. See in-
structions on page 14.
two
passes
F-7756