Primary Belt And Blade Belt - Honda H3011H Owner's Manual

PRIMARY BELT AND BLADE BELT
n Wear or damage
1. Move the P.T.O. lever to the OFF (Disengaged) position.
2. Lower the cutter deck as far as it will go with the cutter deck height ad-
justing lever.
3. Inspect both belts for wear and damage. If the belts are worn or damag-
ed, replace them according to the instructions on pages 59 and 60.
n Blade belt tension
1. Move the P.T.O. lever to the ON (Engaged) position.
2. Lower the cutter deck as far as it will go with the cutter deck height ad-
justing lever.
3. Visually inspect the outside edge position of the tensioner arm. If the
outside edge of the arm reaches the adjustment mark, follow the ad-
justment procedure on page 58 to adjust the belt tension.
BELT
ADJlkTMENT MARK
28