Loader Assembly Installation - Honda FL6555 Operator's Manual

SET-UP INSTRUCTlONS
LOADER ASSEMBLY INSTALLATION
1. Install hinge bolts, hinge pins and hinges
onto loader assembly.
2. Open hinges.
3. Using a suitable overhead hoist or
alternate safe method of lifting the loader
assembly, raise the unit and position it
into loader mounts.
4. Close sub frame hinges and secure by
torquing nuts to 75 foot pounds (102 N
l
m).
5. Check all pivot points to ensure retaining
hardware is in place.
6. Route the two 38" hoses on the "inside"
of the loader upright as shown and secure
with plastic tie strap. Ensure the hoses
are positioned to the rear of the muffler
exhaust port as shown.
7. Connect the two 38" hydraulic hoses to the
tractor hydraulic ports as illustrated.
PLASTIC TIE
21