Honda FL6555 Operator's Manual page 31

OPERATION
Loader Sub Frame Installed With MM60 Mower
You may install your MM60 mower deck with the FL6555 sub frame installed. The front loader
must be removed from the sub frame. If you also have a BH6575 Back Hoe, both the back hoe
and its sub frame must be removed.
pEE-]
You must use the following procedure to adjust the mower linkage to avoid damage to
the deck or linkage.
1. Put the hydraulic position control in the 'DOWN" position.
2. Adjust the left lift rod as shown:
With three-point hitch installed:
without three-point hitch:
3. Follow the normal mower installation in mower operator's manual up to the point of raising
the deck.
LOADER
0.2in
SUB FRAME
-yy-lf#
MOWER DECK STOP
4. Slowly move the hydraulic position control to the "UP" position to raise the deck. Immediately
lower the deck at the first indication of resistance.
5. Check the clearance between the deck stops and the front loader sub frame. Adjust the
clearance to 0.20in (5mm) by adjusting the left lift rod length (shortening the lift rod raises the
deck).
The fully raised position of the deck will be lower with the loader sub frame installed.
29